Put a flexible shaft on the coiling iron core of the conveyor belt, and put the belt coil in a good position. Before putting it on the rack, pay attention to the direction of the upper and lower cover glues not to be reversed.

In the workplace that is not suitable for racking, the conveyor belt can be guided away, and the conveyor belt at the fold can have a large enough radius of curvature to prevent damage to the conveyor belt. It is forbidden to place heavy objects on the conveyor belt at the fold.

If the conveyor belt is to be replaced, the new belt can be connected with the old one, and the unloading of the belt and the installation of the new conveyor belt can be carried out at the same time.

For conveyors running horizontally, the old conveyor can be cut off at any point. For conveyors running in an inclined direction, the cut-off point must be selected to prevent uncontrolled sliding due to its own weight.

After aligning the position of the new belt on the conveyor, fix one end of the belt with a clamp, and then connect it with the rope that bypasses the roller and the pulley, and balance the conveyor belt on the conveyor through the traction device. When the conveyor belt and the frame are pressed against each other.